MAINTENANCE
OPERATOR MANUAL
36
EPS14P
37
OM-EPS14P2019001-EN
DAILY MAINTENANCE
Period and Items
Daily (or every 8 hours) and weekly (or every 40 hours) for daily inspection items, whichever
comes first. If the forklift works less than 8 hours per day, conduct the inspection and checks on
a daily basis. if daily working hours exceed 8 hours, conduct the inspection and checks every 8
hours.
Inspection checklist：
No. Item
1 day 1 week
8 hours 40 hours
1 Exterior Check
2 Wheel Clean and tighten Clean and tighten
3 Mast Check
4 Hydraulic System Check
5 Display Check
6 Warning Equipments Check
7 Brake Check Check
8 Travel, Steering and Control Check
9 Connectors and Fuse Check
10 Clean Clean
11 Others Check
Caution
These inspections should be conducted before operating the forklift.。
Note
Before conducting the daily inspection, recheck for any fault an
d fault found earlier.
Content Description
1. Exterior
(1) Check the forklift body for damage and deformation.
(2) Check the floor where the forklift is parked for oil leakage.
(3) Check the condition of the nameplate and decals.
(4) Check if any parts loose or fall off.
Note
If oil leakage occurs, confirm the location of the oil leakage and contact the BYD after sales
service.
2. Wheel
(1) Check on a daily
basis if the wheel fasteners are secured or loose. Fasten them if they
are loose.
(2) Take out debris embedded in the tire.
(3) If the four tires are unevenly worn, or the tires are found damaged, or the rims are bent,
then replace the wheels.
3. Mast
(1) Check the cylinders, oil pipes, and hoses for oil leakage.
(2) Check the working equipment for deformation and damage. check if the bolts are secure
ly
fastened.
4. Hydraulic System
Check the hydraulic oil level in the oil tank
5. Display
(1) Check if the battery voltage and status of charger displayed are correct.
(2) Check if any fault indicator appears on the display.
6. Warning Equipments
(1) Press horn to see if it works.
(2) Check if other warning equipments work properly.
7. Braking System
Move the handle to the braking zone while the forklift is
travelling, to check whether the brakes
operate efficiently.
8. Travel, Steering and Control Inspection
(1) Check for the operation of the tiller and abnormal sounds by rotating the tiller forward or
backward and turning the tiller right or left.
(2) Check for the operation of buttons.
(3) Check the fasteners for looseness or missing.
To Next Page
Loading...
