MAINTENANCE
OPERATOR MANUAL
48
EPS14P
49
OM-EPS14P2019001-EN
Gear Oil Replacement
(1) Clean the surrounding areas around the oil filler plug and the oil drain plug, and place a
suitable vessel under the oil.
(2) Unscrew the oil filler plug and the oil drain plug with sealing rings.
(3) After draining, screw in the oil drain plug with the sealing ring.
(4) Add gear oil until the oil level is at the lower edge of the oil filler plug. Screw in the oil filler
plug
with the sealing ring.
11
12
13
12
CODE PART NAME QTY CODE PART NAME QTY
11
OIL FILLER PLUG
1 30 N-m 13
OIL DRAIN PLUG
1 30 N-m
12
SEALING RING
2
Caution
(1) Oil drain time of approximate 5 minutes must not be exceeded.
(2) When filling the oil, care about the condition around to prevent dust and water entering
the oil tank.
(3) When disposing the waste oil, keep people away and do not pour it into the sewer or onto
the ground.
(4) The oil level should
be just at the lower edge of the oil filler hole.
MAST MAINTENANCE
Chains Adjustment
The standard mast has the main lift chain that is needed to be adjusted, the free list mast has
the main lift chain set and the free lift chain that are needed to be adjusted. Before adjustment,
park the forklift on a level ground and fully lower the mast, switch off the forklift, take off the key
and press down the emergency switch.
1. Standard Mast Lift Chain Adju
stment
Loosen the upper and lower nuts of the lift chain, and then screw the middle nut to adjust the
length of the chain. After adjustment, make the forks remain level and the chains remain the same
tightness, and them tighten nuts.
12
13
11
CODE PART NAME QTY CODE PART NAME QTY
11
NUT (UPPER)
1 110 N-m 13
NUT (LOWER)
1 110 N-m
12
NUT (MIDDLE)
1 110 N-m
Caution
After adjustment, make sure that the chains aren't slack when the lift cylinder is in the original
position.
To Next Page
Loading...
