C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
6.3. Setup
1. Connect all the cables and components as depicted in the previous section illustrating
the setup schematics. Select connection that is best suited for your application.
2. Power on the iNetVu
®
7710 Controller.
3. Set your external PC to the same subnet as the iNetVu
®
7710 Controller (Default
controller IP Address of the 7710 controller is (192.168.0.2)
4. Refer to the appropriate service User Manual that will be used with your system for
addition setup and configuration information.
5. Controller should be power cycled (reset/rebooted) after each and every configuration
change.
To Next Page
Loading...