C-COM Satellite iNetVu 7710 - E&A&P

C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
55
E&A&P
Will allow for Demo Testing on all axes (elevation, azimuth, and
polarization) for a user specified angle range.
DPLY
Deploys the antenna to a user specified azimuth, elevation, and
polarization position.
DPLY_C
Will read the compass heading at a user specified elevation, azimuth,
and polarization target point.
CP
Tests the compass’ heading and accuracy by rotating the antenna at
90° intervals and comparing the compass readings with the actual
antenna’s movement.
A_ACP
Performs an automatic ACP test for Hughes service.
M_ACP
Performs a manual ACP test for Hughes service.
S_ACP
This operation will stop the ACP test from continuing.
7.11.1. E&A&P
Fig. 44: Test/Demo EL,AZ, PL Configuration
1 – Elevation Range
Allows the user to set the start and stop angle of the elevation axis, as well as set the specific
speed for elevation movement. (E +20:70:7 –implies from angle 20 to 70 at speed 7)
2 – Polarization Range
Allows the user to set the start and stop angle of the polarization axis, as well as set the specific
speed for polarization movement. (P -60:60:7 –implies from angle -60 to 60 at speed 7)
3 – Azimuth Range
Allows the user to set the start and stop angle of the azimuth axis, as well as set the specific
speed for azimuth movement. (A -180:180:7 –implies from angle -180 to 180 at speed 7) Fly-
away systems will have a different range.
E +20:70:7 P-60: 60:7
A-180: 180:7 DD: D TST
1
2
3
4
5