C-COM Satellite iNetVu 7710 - Sat; MDM

C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
46
7.10.1. SAT
This menu allows for the configuration of the target satellite(s) and the reference satellite.
Fig. 34: Target Satellites display
1 – Multiple Satellite Search
This feature when enabled will allow the search to be carried out on three listed target satellites. The
search will automatically switch to the next listed target if the previous target search fails.
D – Disabled
E – Enabled
When Multiple Satellite Search feature is enabled the three Target Search Satellites will be
displayed.
2 – Target Satellite
Satellite Beam ID and orbital slot/Longitude of the satellite. The Find Satellite command will use
this beam information that is configured under the Satellite and DVB Transponder Settings when
attempting to find and lock onto the satellite signal.
7.10.2. MDM
Fig. 35: Modem Configuration
1 – Beam ID
Configured Satellite Modem to read the Beam ID from the Controller, Modem or Beam ID Table. (HNS
Only).
MSS:D BM01_072.0W
2
1
B 01 091. 0W S2A
1468.0 50000 VV D
1
5
6
4
7
2
3
MSS:E BM01_072.0W
BM02_087.0W BM03_091.0W