C-COM Satellite iNetVu 7710 - Page 34

C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
34
4 - Transponder Number
(There are usually six (6) transponders for each satellite stored into the controller memory) 0 – 2 are
horizontal Receive, and 3-5 are vertical receive) the user may overwrite the transponder data with
his/her own (see configuration section).
5 - DVB Transponder Frequency (KHz)
6 – Transponder Symbol Rate (sps)
7 –Transponder Code Rate.
DB-1 = 1/2
DB-2 = 2/3
DB-3 = 3/4
DB-5 = 5/6
DB-7 = 7/8
AUTO (DVB-S1 or DVB-S2A SELECTION)
8 – Power Supplied to LNB from the Controller for the Target Satellite
7.7.8. S2
This menu displays the Reference Satellite Status, Longitude, Target Antenna Coordinates,
DVB Transponder (Frequency, Symbol Rate, and Code Rate) and LNB Power. The reference
satellite is another search option that could be utilized by the user. If this option is disabled, only
the beam reference satellite will be displayed.
Fig. 22: “S2” (Reference Satellite) Display
1 – Reference Satellite Longitude, Hemisphere, and Status
Status “D”: implies the reference satellite option is disabled
Status “E”: implies the target satellite option is enabled
2 – Reference Satellite Antenna Elevation, Azimuth, and Polarization coordinates respectively.
D 63W E0 A0 P0
0 0990 30000 DB-7 18
1
4
6
2
5
3
7