C-COM Satellite iNetVu 7710 - Page 94

C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
94
HNS_KA Modem options
Hughes Ka service modem will automatically propagate and fill in all the fields except the IP and
longitude when BEAM_T mode is selected. Parameters are generally the same as the HNS_KU
service type.
Mode
BEAM_T – Modem Beam parameters information are retrieved from Beam table and used for satellite
search.
CONFIG – Modem parameters information is manually entered into the fields and used for satellite
search.
Longitude
Orbital slot / Longitude of the desired Satellite. This value must match Longitude value on controller side.
Rx-Pol
Receive Polarization set in the satellite modem, Hughes Net service only.
Tx-Pol
Transmit Polarization set in the satellite modem, Hughes Net service only.
LNB 22 KHz Tone
The 22 KHz tone can be disabled or enabled for supporting modems.