C-TEC QT601-2 - 2.9 Setting Up the Paging Options; Setting up DECT Protocol

2.9 Setting Up the Paging Options
R
efer to Appendix 5 (Quantec Paging Functionality) for
further details.
If radio paging equipment is connected to the Controller's
RS232 paging terminal, this menu must be selected to enable
it to operate. On selecting the ‘Paging’ prompt, it is possible
to scroll through the following options:
Setting up Pager Modes:
On selecting the ‘Pager Mode’ prompt,
it is possible to scroll through the
following two options:
accepting this allows connection to a
pager transmitter.
accepting this allows connection to a
DECT system.
Setting up Pager Levels:
On selecting the ‘Pager Level’ prompt,
it is possible to scroll through the
following options:
accepting this disables all paging
functions (no calls of any type will be
sent to pagers).
accepting this enables paging on
ATTACK calls only.
accepting this enables paging on
EMERGENCY and ATTACK calls only.
accepting this enables ALL levels of
call (except PRESENCE).
accepting this enables paging on
ASSIST, EMERGENCY and ATTACK calls
only. Note: ASSIST = HELP REQUIRED.
accepting this enables ALL levels of
call.
accepting this enables paging on
RESET and ALL levels of call.
It should be noted that different levels of calls are not
prioritised by pagers. For example, if a STANDARD call is
triggered followed by an EMERGENCY call, the EMERGENCY
call will not be displayed until the STANDARD call has been
accepted and the next message called up. Calls will however
still be prioritised in the usual manner at QT608C Displays, i.e.
highest priority calls first.
QT601-2 Quantec Controller
Installation & Programming Manual • Approved Document No. DNU6012001 Rev 5 • Page 22 of 42
Setting up DECT Protocol:
On selecting the ‘DECT Protocol’
prompt, it is possible to scroll through
the following two options:
accepting this selects DECT MEP
protocol.
accepting this selects DECT ESPA
protocol.
IMPORTANT NOTE: For setting up detailed Paging and DECT
functions use the in-built Help file supplied with the QT707
upload/download software.
Pager DISABLED
Pager ENABLED on
ATTACK only
Pager ENABLED on
EMERG & Higher
Pager ENABLED on
CALL & Higher
Pager Mode
Set Paging
Mode: Radio
D
ECT Protocol
DECT Protocol
Mode: MEP
Pager Level
Set Paging
Mode: DECT
Pager ENABLED on
ASSIST & Higher
Pager ENABLED on
PRESENCE & Higher
Pager ENABLED on
RESET & Higher
D
ECT Protocol
Mode: ESPA