C-TEC QT601-2 User Manual

QT601-2 Quantec Controller
Appendix 6 - Wiring for Addressable Call Points / Ceiling Receivers
This appendix shows two example methods for wiring Quantec Addressable Call Points/Ceiling Receivers (all variants) with
connections to typical slave ancillary devices. This incorporates the following devices:
QT602 Addressable Call Points; QT602E Addressable Call Points; QT609 Addressable Call Points;
QT302RX Master IR Ceiling Receivers; QT302RXS Slave IR Ceiling Receivers;
QT606 Slave Overdoor Lights; QT606S Slave OD Lightds c/w Sounder;
QT607 Slave Ceiling Pulls;
Q
T602D Slave Call Points.
{{
MASTER
CALL POINT
(all variants)
IR
RESET ID
ID RESET PINS (PLK2)
Short to clear the device’s ID
number when powered.
– + R G
L+ SW
CONNECTION TO QUANTEC NETWORK
VIA SLAVE OVERDOOR LIGHT
SLV
Slave Call
Input
–
+ R G
L
+
S
W
REMOTE IR INPUT
V
+
V–
S
MOM
S
ER
IR
{
Do not use
– + R G L+ SW
SET ID PINS (PLK3 on QT302RX only)
For the optional connection of
third-party switches and buttons.
SLAVE CALL INPUT
QT423 CONFIGURATOR CONNECTOR (PLK1)
For optional special programming functions
(requires QT423A adaptor)
LL
AC
LK3P
{
{
{{
K4LP
Short to give the QT302RX an ID when in
assignment mode (once assigned, these
pins can be used to make diagnostic calls).
RESET PINS (PLK4 on QT302RX only)
For resetting diagnostic calls only.
+V
S
R
Local
Switch
QT607
CEILING PULL
(OPTIONAL)
QT602D
SLAVE CALL POINT
(OPTIONAL)
G Green light
R Red Light
– Network -Ve
– Network -Ve
+ Network +Ve
+ Network +Ve
+
–
+
–
QT606 SLAVE
OVERDOOR LIGHT
(OPTIONAL)
SLAVE IR RECEIVER
QT302RXS
QT602D SLAVE
CALL POINT
(OPTIONAL)
Max. 3 slave call points or
ceiling pulls (any mix,
connected in parallel)
per master call point.
Max. 3 slave IR receivers
(connected in parallel)
per master ceiling
receiver/call point.
Max. 3 slave call points or ceiling pulls
(any mix, connected in parallel)
per master call point.
R
L+
L+
–
(on master)
(on master)
The TOTAL number of slave
devices with confidence
LEDs across all of an
addressable call point's
inputs must not exceed 3.
K2LP
QT606S SLAVE
OVERDOOR
LIGHT
C/W SOUNDER
(OPTIONAL)
– + R G
NET
REM
ODL
DISINT
VOLUME
HL EB
REM
BEEP
QUANTEC NETWORK
{{
QUANTEC NETWORK
Red
{
{
Installation & Programming Manual • Approved Document No. DNU6012001 Rev 5 • Page 30 of 42

C-TEC QT601-2 Specifications

General

Brand	C-TEC
Model	QT601-2
Category	Controller
Language	English