CAB A4 User Manual

97cab Produkttechnik GmbH & Co KG
10. Memory Cards
8. The data that was read from the source card will now be transferred onto
the destination card. As this is happening the progress bar on the LCD
will be emptied.
If not all files were read from the source card yet; the request "Insert
source" will appear on the LCD.
9. Remove the destination card and insert the source card again. The next
cycle of copying will start.
10. Repeat steps 6 to 9 until all the files are copied. When the printer finishes
copying the files the LCD will display "OK ".
11. Press the key to return to the "Memory card" menu selection list.
When the destination card cannot store any more information the LCD will
display "Card full".

CAB A4 Specifications

General

Printer Type	Thermal transfer / direct thermal
Interfaces	USB, Ethernet, RS232
Label Thickness Range	0.05 mm - 0.25 mm
Memory	8 MB Flash
Power Supply	100-240 VAC, 50/60 Hz
Operating Temperature	+5°C to +40°C
Print Resolution	203 dpi
Humidity Range	10-85% non-condensing