Attention!
Printhead damage caused by improper handling!
Do not touch the underside of the printhead with the ngers or sharp objects.
Ensure that the labels are clean.
Ensure that the label surfaces are smooth. Rough labels act like emery paper and reduce the service life
of the printhead.
Print with the lowest possible printhead temperature.
The printer is ready for operation when all connections have been made and labels and, if applicable, the transfer
ribbon have been loaded.
5.1 Printing in Tear-off Mode
After printing the label is torn-off manually. For this the printer is equipped with a tear-off plate.
5.2 Printing in Cutting Mode
For EOS2 and EOS5 cutters are available as accessory. With the cutter installed labels and endless material can be
cut-off automatically after printing.
To Next Page
Loading...
Need help?
General
