CAB HERMES Q4L User Manual

23
7 Fault Correction
7.1 Error Display
The appearance of an error will be shown on the display:
Figure 21 Error display
The error treatment is pending on the error type  7.2 on page 23.
The display offers the following possibilities to continue after an error occurred:
Repeat The print job will be continued after clearing the error cause.
Cancel The print job will be cancelled.
Feed The paper feed will be synchronized. Following the print job can be continued.
Ignore The error message will be ignored. The print job will be continued possibly with limited
performance.
Save log The error does not allow print operation.
Fordetailedanalysisseveralsystemlescanbesavedonanexternalmemory.
Table 5 Buttons in the error display
7.2 Error Messages and Fault Correction
Error message Cause Remedy
Barcode error Invalid barcode content, e.g. alphanumeric
characters in a numerical barcode
Correct the barcode content.
Barcode too big The barcode is too big for the allocated
area of the label
Reduce the size of the barcode or move it.
Buffer overow The input buffer memory is full and the
computer is still transmitting data.
Use data transmission via protocol (preferably
RTS/CTS).
Device not conn. Programming addresses a non-existent
device
Either connect this device or correct the
programming.
File not found
Requestedleisnotonthecard Check the contents of the card.
Font not found Error with the selected download font Cancel current print job, change font.
Memory overow Current print job contains too much infor-
mation, e.g. selected font, large graphics
Cancel current print job.
Reduce amount of data to be printed.
Name exists
Duplicateusageofeldnameinthedirect
programming
Correct programming
No label found There are labels missing on the label
material
Press Repeat repeatedly until printer recognizes the
next label on the material.
The label format as set in the software
does not correspond with the real label
format
Cancel current print job.
Change the label format set in the software.
Restart print job.
No label size
Thesizeofthelabelisnotdenedinthe
programming.
Check programming.
Out of paper Out of label roll Load labels.
Error in the paper feed Check paper feed.

CAB HERMES Q4L Specifications

General

Brand	CAB
Model	HERMES Q4L
Category	Label Maker
Language	English