5-10 6907 Input Channel
J-Type Revision J2005-2
81514 ,QSXW#*DLQ
The input gain is continuously variable from -10dB (minimum) to +60dB. Combined
with the use of the -20dB Pad, this allows the use of a wide range of input devices,
including ribbon, dynamic electret and capacitor microphones; CD players, profes-
sional reel-to-reel tape machines; etc.
81515 'LUHFW#223#3UH23RVW
Press the DIRECT OUTPUT PRE to have the Channel Direct O/P signal derived
from before the channel fader.
81516 26&231*#%XV#6HOHFW
The “~” switch connects the OSC/PNG bus to the input amplifier.
You may select a sine wave tone for line-up purposes, or pink noise for loudspeaker
calibration (selectable on OSC/PNG/COMMS module).
9<3:#,QSXW#&KDQQHO
5.2.1 Input Gain
5.2.6 Insert
5.2.7 48V Phantom Power
5.2.8 Routing to Sub Groups
5.2.10 PAN
5.2.2 Direct O/P Pre/Post
5.2.3 OSC/PNG Bus Select
5.2.4 20dB Pad
5.2.5 Phase Change
5.2.9 PAN In/Out
To Next Page
Loading...