5-14 6907 Input Channel
J-Type Revision J2005-2
815148 +)#(4#,Q 22XW
Switches the EQ section In/Out of circuit.
815149 +)#(4#%HOO26KHOI#VZLWFK
Changes the response of the equalizer from BELL (default response) to SHELF.
81514: +)#4#&RQWURO
The Q-control varies the bandwidth of the boost/cut at the frequency chosen (Q is
only available in the default BELL response). A low Q-value gives a wide bandwidth.
This means a that a relatively large range of frequencies, either side of the centre fre-
quency, have boost/cut applied. When the Q-value is high, the bandwidth is reduced,
so that a much smaller range of frequencies have boost/cut applied.
81514; & RQ WUR O #IRU#0)#ERRVW2FXW
Defines the amount of equalization (±18dB) applied to the mid frequency band.
81514< 0LG#) UHTXHQF\#&RQWURO
This control allows you to choose the “centre” frequency at which the boost/cut is
applied.
815153 0)#(4#,Q22XW
Switches the EQ section In/Out of circuit.
815154 0)#4#&R QWURO
The Q-control varies the bandwidth of the boost/cut at the frequency chosen (Q is
only available in the default BELL response). A low Q-value gives a wide bandwidth.
This means a that a relatively large range of frequencies, either side of the centre fre-
quency, have boost/cut applied. When the Q-value is high, the bandwidth is reduced,
so that a much smaller range of frequencies have boost/cut applied
815155 & RQ WUR O #IRU#/)#ERRVW2FXW
Defines the amount of equalization (±18dB) applied to the mid frequency band.
815156 /RZ#) UHTXHQF\#&RQWURO
This control allows you to choose the “centre” frequency at which the boost/cut is
applied.
815157 /)#(4#,Q22XW
Switches the EQ section In/Out of circuit.
To Next Page
Loading...