8-6 7935 Stereo Input Motor fader
J-Type Revision J2005-2
;15143 1XOO#SRLQW#/('V
These two LEDs indicate the direction in which the fader should move when a cue
with static fader data is recalled. The fader is at the ‘null’ position when the LEDs are
off. If the upper LED is illuminated, the fader is above the ‘null’ point and if the lower
LED is illuminated, the fader is below the null point.
;15144 )DGHU
A 100 mm standard fader controls the signal level to the sub group and post-fader
Aux Sends. The fader position can be saved and recalled as part of a normal cue or
a dynamic cue.
;15145 /('#PHWHU
Two 20-segment LED bargraph meters indicate the stereo channels level post EQ
and INSERT points.
;15146 )DGHU#2SHQ
This LED lights when the fader is open and not muted (and when any assigned DC
Master is open and not muted).
To Next Page
Loading...