Cadac J-Type - Page 43

J-Type CCM 2-15
Revision J2005-2 J-Type
■
■■
■
Press [
↵
], followed by the Down Arrow button, until the display shows “
Test Motor
Fders?
”
■
■■
■
Press [
↵
]. The Motor faders should now move up and down (they move slower at
the bottom end). Check that all Motor faders are moving at the same rate and that
they run smoothly.
■
■■
■
Press
[Esc]
to return to the system menu or Down arrow to perform next test.
519144 7HVW#NH\V
In the system menu, select “
Test System?”
using the Up or Down arrow button.
The display shows “
Test System?”.
■
■■
■
Press [
↵
], followed by the Down Arrow button, until the display shows “
Te st
Keys?
”
■
■■
■
Press [
↵
]. The display shows
“Button = ...”
■
■■
■
Press each of the buttons, including the P & N buttons (but not the Esc button) in
turn, ensuring that the display shows what button has been pressed.
■
■■
■
Check also the external P & N.
Press
[Esc]
to return to the system menu.
519145 7HVW#0,',
In the system menu, select “
Test System?”
using the Up or Down arrow button.
The display shows “
Test System?”.
Press [
↵
], followed by the Down Arrow button, until the display shows “
Test MIDI?
”
■
■■
■
Press [
↵
]. This test outputs programme change to the MIDI-connections on the
back of the CCM, indicating channel changes in ascending order for MIDI A (1-16)
and in descending order for MIDI B (16-1).
To perform a cable test and to ensure MIDI-cables have not been crossed over, a
cable can be connected between MIDI out and MIDI in. This will cause a flashing “A”
if connected between MIDI A output and MIDI A input and a flashing “B” if connected
between MIDI B output and MIDI B input.
Press [Esc] to return to the system menu or Down arrow to perform next test.
519146 7HVW#HYHQWV
In the system menu, select “
Test System?”
using the Up or Down arrow button.
The display shows “
Test System?”.
■
■■
■
Press [
↵
], followed by the Down Arrow button, until the display shows “
Te st
Events?
”
■
■■
■
Press [
↵
]. Make sure that the Events enable switch is on. The LED’s indicating
events should now come on and off in sequence. Turning the enable switch off
should cause all the LED’s to extinguish.
■
■■
■
Press [Esc] to return to the system menu or Down arrow to perform next test.
519147 7HVW#&RPPV
In the system menu, select “
Test System?”
using the Up or Down arrow button.
The display shows “
Test System?”.
Press [
↵
], followed by the Down Arrow button, until the display shows “
Test Comms?
”