7865 Stereo Input Channel 3-3
Revision J2005-2 J-Type
61416 ,QSXW#/HIW#²53G%#3DG
Press this button to change the input from “microphone sensitivity” to “line level”. The
‘20dB’ pad is inserted before the input amplifier.
61417 ,23#4#3KDQWRP#3RZHU
Press this button to connect 48V phantom power to the stereo left input connec-
tor.This function has a slow ’ramp-up’ (approximately 30 seconds to get from 0v to
48v). Note that this function is interlocked with the oscillator, see 3.1.7.
61418 ,23#4#3KDVH#&KDQJH
When this button is selected, the stereo left input signal phase is reversed (180°).
61419 ,QSXW#/HIW#2Q22II
Input on/off switches are provided on both left and right inputs for maximum versatil-
ity under program control.
6141: 2VFLOODWRU#EXV#6HOHFW
Press this button to connect Left and Right inputs to the ‘Oscillator/PNG’ bus. For this
function to work, the ‘Oscillator/PNG’ module must be selected to “CHANNELS”.
This facility allows you to check that an individual module, or the whole console is
working correctly.
Please note that this switch is interlocked with the 48V switches such that if one is
ON, you cannot select the other.
6141; 'LUHFW#223#¶3UH·#(4
The default setting for the channel ‘direct output’ circuit is post-EQ and pre-fader.
When the ‘direct output’ is used to feed an external monitor mixer or recording
machine, it is possible that the EQ settings for the ‘front-of-house’ mix will clash will
the requirements for these purposes. Press the “PRE EQ” button to derive the ‘direct
output’ signal ‘pre’ the channel EQ.
6141< ¶3D Q#3RW·#,QVHUW
Press this button to insert the ‘pan pot’.
614143 ,QSXW#5LJKW#*DLQ
As 3.1.1 for the ‘right-hand’ input.
614144 ,QSXW#5LJKW#3)/
As 3.1.1 but for the ‘right-hand’ input.
To Next Page
Loading...