3-4 7865 Stereo Input Channel
J-Type Revision J2005-2
614145 ,QSXW#5LJKW#²53G%#3DG
As 3.1.3, but for the ‘right-hand’ input.
614146 ,QSXW#5LJKW#3KDQWRP#3RZHU
As 3.1.4, but for the ‘right-hand’ input.
614147 ,QSXW#5LJKW#3KDVH#&KDQJH
As 3.1.5, but for the ‘right-hand’ input.
614148 ,QSXW#5LJKW#2Q22II
See 3.1.6.
614149 ,QSXW#DPSOLILHU#,VRODWH
This function ‘isolates’ the switch data (for both input amplifiers) from the computer.
There are many instances during a production rehearsal, when module routing or
level changes need to be made to solve a problem. When you are rehearsing a
sequence of cues, there may not be time to record the changes in all of the cues that
are affected. When you press the ‘ISOLATE’ button, previously recorded switch data
will be ignored by the module, leaving the switches at their new setting until you can-
cel the function.
61414: 'LUHFW#223#¶3RVW·#&KDQQHO#)DGHU
The default setting for the channel ‘direct output’ circuit is post-EQ and pre-fader.
Press the “TRK FD” button when you need to control the ‘direct output’ level with the
channel fader.
61414; 6XE#*URXS#5RXWLQJ#6ZLWFKHV
Sixteen switches that allow you to route the channel signals to one or all of the Sub
Group routing bus’.
61414< ¶3DQ#3RW·
A dual-concentric potentiometer, where the upper knob controls ‘panning’ for the Left
input and the lower (or outer) knob controls ‘panning’ for the Right input. When the
‘Pan Pot’ Insert switch is selected, either input signal can be ‘panned’ between any
pair of odd and even Sub Groups.
Note that the ‘pan pot’ also controls ‘panning’ to the Stereo Auxiliary Send.
To Next Page
Loading...