7496 Dual Input Channel 3-13
Revision J2005-2 J-Type
61516 ,23#4#3)/
Press this button to ‘listen’ to the signal on I/P1 only (pre routing and EQ).
61517 ,23#4#²53G%#3DG
Press this button to change the input from “microphone sensitivity” to “line level”. The
‘20dB’ pad is inserted before the input amplifier.
61518 ,23#4#3KDQWRP#3RZHU
Press this button to connect 48V phantom power to the input connector. This func-
tion has a slow ’ramp-up’ (approximately 30 seconds to get from 0v to 48v).
61519 ,23#4#3KDVH#&KDQJH
When this button is selected, the input signal phase is reversed (180°).
6151: ,23#4#2Q22II
Input on/off switches are provided so that input signals can be changed (switched
on-to-off or vice-versa) under program control.
6151; ,23#5#*DLQ
As 3.2.1, but for input 2.
6151< ,23#5#1XOO#/('
As 3.2.2, but for input 2.
615143 ,23#5#3)/
As 3.2.3, but for input 2.
615144 ,23#5#²53G%#3DG
As 3.2.4 but for input 2.
615145 ,23#5#3KDQWRP#3RZHU
As 3.2.5, but for input 2.
615146 ,23#5#3KDVH#&KDQJH
As 3.2.6, but for input 2.
615147 ,23#5#2Q22II
As 3.2.7, but for input 2.
To Next Page
Loading...