EasyManua.ls Logo

Cadac J-Type - Page 67

Cadac J-Type
200 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7496 Dual Input Channel 3-17
Revision J2005-2 J-Type
61515; $X[#6HQG#¶2Q22II·
The default setting for the channel auxiliary send circuits is ‘off’ and post-fader.
Press the “ON” button to switch the aux send section into circuit.
61515< $X[#6HQG#/HYHO
Level control for an auxiliary send section.
The position of the ‘level’ potentiometer is recorded during a SAVE command.
615163 $X[#6HQG#3RW#1XOO#/('
The Null LED will be illuminated if the position of the ‘aux send pot’ is different from
the programmed position. To recall the programmed position, rotate the potentiome-
ter until the LED goes ‘out’.
615164 6WHUHR#$X[#6HQG#¶3UH0(4·
The default setting for the channel auxiliary send circuits is ‘off’ and post-EQ.
Press the ‘PRE’ button until the PRE EQ LED illuminates to derive the stereo aux
send signal pre-EQ.
615165 6WHUHR#$X[#6HQG#¶3UH0)DGHU·
The default setting for the channel auxiliary send circuits is ‘off’ (post-fader).
Press the “PRE” button until the PRE FD illuminates to derive the stereo aux send
signal pre-fader.
615166 6WHUHR#$X[#6HQG#¶2Q22II·
The default setting for the channel auxiliary send circuits is ‘off’ (post-fader).
Press the “ON” button to switch the stereo aux send section into circuit.
615167 6WHUHR#$X[#6HQG#/HYHO#3RW#1XOO#/('
The Null LED will be illuminated if the position of the ‘stereo aux send pot’ is different
from the programmed position. To recall the programmed position, rotate the potenti-
ometer until the LED goes ‘out’.
615168 6WHUHR#$X[#6HQG#/HYHO#DQG#¶3DQ·
A dual-concentric potentiometer where the ‘inner’ knob is the level control for the ste-
reo auxiliary send section and the ‘outer’ knob is the stereo aux ‘pan pot’. The posi-
tions of the ‘level’ and ‘pan’ potentiometers are recorded during a SAVE command.
615169 6WHUHR#$X[#6HQG#¶3 DQ#3RW·#1XOO#/('
The Null LED will be illuminated if the position of the ‘stereo aux pan pot’ is different
from the programmed position. To recall the programmed position, rotate the potenti-
ometer until the LED goes ‘out’.