3-26 7830 Dual input channel
J-Type Revision J2005-2
recorded switch and pot data will be ignored by the module, leaving the controls at
their new setting until you cancel the function.
61614: 'LUHFW#223#¶3UH·#(4
The default setting for the channel ‘direct output’ circuit is post-EQ and pre-fader.
When the ‘direct output’ is used to feed an external monitor mixer or recording
machine, it is possible that the EQ settings for the ‘front-of-house’ mix will clash will
the requirements for these purposes.
Press this button to derive the ‘direct output’ signal ‘pre’ the channel EQ.
61614; 'LUHFW#223#¶3RVW·#&KDQQHO#)DGHU
The default setting for the channel ‘direct output’ circuit is post-EQ and pre-fader.
Press this button when you need to control the ‘direct output’ level with the channel
fader.
61614< 6XE#*URXS#5RXWLQJ#6ZLWFKHV
Sixteen switches that allow you to route the channel signal to one or all of the Sub
Group routing bus’.
616153 #¶3DQ#3RW·#,QVHUW
Press this button to insert the ‘pan pot’. The adjacent LED indicates function has
been selected.
3.3.19 Sub Group Routing Switches
3.3.21 Pan Pot Null LED
3.3.22 Pan Pot
3.3.20 Pan Pot Insert switch and LED
:;63#'XDO#,QSXW#&KDQQHO
To Next Page
Loading...