7830 Dual input channel 3-25
Revision J2005-2 J-Type
61619 ,23#4#3KDVH#&KDQJH
When this button is selected, the input signal phase is reversed (180°).
6161: ,23#4#2Q22II
Input on/off switches are provided so that input signals can be changed (switched
on-to-off or vice-versa) under program control.
6161; ,23#5#*DLQ
As 3.3.1, but for input 2.
6161< ,23#5#1XOO#/('
As 3.3.2, but for input 2.
616143 ,23#5#3)/
As 3.3.3, but for input 2.
616144 ,23#5#²53G%#3DG
As 3.3.4, but for input 2.
616145 ,23#5#3KDQWRP#3RZHU
As 3.3.5, but for input 2.
616146 ,23#5#3KDVH#&KDQJH
As 3.3.6, but for input 2.
616147 ,23#5#2Q22II
As 3.3.7, but for input 2.
616148 2VFLOODWRU#%XV#6HOHFW
Press this button to connect inputs 1 and 2 to the ‘Oscillator/PNG’ bus. For this func-
tion to work, the ‘Oscillator/PNG’ module must be selected to “CHANNELS”. This
facility allows you to check that an individual module, or the whole console is working
correctly.
616149 ,QSXW#$PSOLILHU#,VRODWH
This function ‘isolates’ the switch and potentiometer recall data (for both input ampli-
fiers) from the computer. There are many instances during a production rehearsal,
when module routing or level changes need to be made to solve a problem. When
you are rehearsing a sequence of cues, there may not be time to record the changes
in all of the cues that are affected. When you press the ‘ISOLATE’ button, previously
To Next Page
Loading...