7830 Dual input channel 3-29
Revision J2005-2 J-Type
616159 $X[#6HQG#3RW#1XOO#/('
The Null LED will be illuminated if the position of the ‘aux send pot’ is different from
the programmed position. To recall the programmed position, rotate the potentiome-
ter until the LED goes ‘out’.
61615: 6WHUHR#$X[#6HQG#¶3UH0)DGHU·
The default setting for the channel auxiliary send circuits is ‘off’ and post-fader.
Press the “PRE FD” button to derive the stereo aux send signal pre-fader.
61615; 6WHUHR#$X[#6HQG#¶2Q22II·
The default setting for the channel auxiliary send circuits is ‘off’ and post-fader.
Press the “ON” button to switch the stereo aux send section into circuit.
61615< 6WHUHR#$X[#6HQG#/HYHO#3RW#1XOO#/('
The Null LED will be illuminated if the position of the ‘stereo aux send pot’ is different
from the programmed position. To recall the programmed position, rotate the potenti-
ometer until the LED goes ‘out’.
616163 6WHUHR#$X[#6HQG#/HYHO#DQG#¶3DQ·
A dual-concentric potentiometer where the ‘inner’ knob is the level control for the ste-
reo auxiliary send section and the ‘outer’ knob is the stereo aux ‘pan pot’. The posi-
tions of the ‘level’ and ‘pan’ potentiometers are recorded during a SAVE command.
616164 6WHUHR#$X[#6HQG#¶3 DQ#3RW·#1XOO#/('
The Null LED will be illuminated if the position of the ‘stereo aux pan pot’ is different
from the programmed position. To recall the programmed position, rotate the potenti-
ometer until the LED goes ‘out’.
To Next Page