3-34 7830 Dual input channel
J-Type Revision J2005-2
ing a sequence of cues, there may not be time to record the changes in all of the
cues that are affected. When you press the ‘ISOLATE’ button, previously recorded
switch and pot data will be ignored by the module, leaving the controls at their new
setting until you cancel the function.
616187 0DLQ#3)/
Press this button to ‘listen’ to the channel signal pre-fader.
616188 3RWHQWLRPHWHU#¶5HFDOO·#:DUQLQJ
This LED will ‘flash’ when any potentiometer on the module is at a different position
to that recorded in the current cue.
616189 &KDQQHO#0XWH
Press this button to mute the channel manually.
The MUTE switch also has a secondary function when used in conjunction with the
CHECK switch, (located on the OSC Module). If a channel is muted (MUTE switch
‘On’) and the CHECK switch is pressed, the muted channel is unmuted, but all other
channels are forced into MUTE. This allows the originally muted channel(s) to have a
‘SOLO’ function.
61618: ¶5HFDOO·#1XOO#'LUHFWLRQ#/('V
A pair of LEDs that indicate the direction you need to turn the current potentiometer
to achieve the ‘null’ position. When the ‘null’ point is reached, both LEDs will turn
‘off’. Turning any pot will make it the current pot.
To Next Page
Loading...