4-6 7925 Programmable Group Module
J-Type Revision J2005-2
LEDs surrounding the control. Each LED indicates approximately a 2dB change. The
rate of change is ‘speed’ dependent. At the slowest ’speed’ each increment is
approximately 1/4 dB. Max attenuation is >60dB. Pressing the knob will increment
the selection to the next cross-point.
714156 6XE#WR#0DWUL[#5HVWRUH
Resets the selected cross-point to its previously stored level.
714157 6XE#WR#0DWUL[#6HOHFW
Used in conjunction with the Routing switches to select which cross-point is available
on the rotary level set control. Resets after the cross-point is selected to the rotary
control.
714158 6XE#WR#0DWUL[#,VRODWH
Isolates the Sub to Matrix routing buttons from the Cue Automation. It also inhibits
the recall of the stored Sub to Matrix VCA levels.
714159 6XE#WR#0DWUL[#6HOHFWLRQ#/RFN
Used to lock the SELECT mode ON.
To Next Page
Loading...