Instrument Comms Settings
Configuring Instrument Comms Settings
8
To enter settings into memory
Press and hold ▲ and ▼ for 3 seconds display alternates
INPT and
nonE
To check settings; repeat the above procedure
The unit is now ready to be configured from the PC.
Note: Where more than one instrument is connected to the
system, it is useful at this point to list them by location, title
and comms address. The list can then be used as a reference
to ensure that the the instruments are given the same identity
when configuring the comms link from the PC.
To Next Page
Loading...
