Fractional Settings
When ConcreteCalc is set to its default
state, it rounds fractional values to the
nearest 1/16 of an inch. However, you
may program your preference for six
different accuracy levels and two dif-
ferent modes (Normal and Fixed), all of
which remain in permanent memory
until revised or reset.
The fractional level can be revised by
using the keystrokes below:
Keystroke Fraction Setting
[Conv] 1 1/16
[Conv] 2 1/2
[Conv] 3 1/32
[Conv] 4 1/4
[Conv] 6 1/64
[Conv] 8 1/8
Note: Whenever the calculator is set to any-
thing other than 1/16 normal mode, a star
(
★
) will appear in the bottom left of the dis-
play during power up to indicate a special
fractional setting has been stored within.
The fractional setting can be displayed at
any time by pressing [Rcl] [/].
User’s Guide – 25
To Next Page
Loading...
