Calculated Industries Construction Master 5 - Default and Preference Settings

POCKET REFERENCE GUIDE — 39
Default Settings
After a Clear All (Ç x), your calculator
will return to the following settings:
STORED VALUES DEFAULT VALUE
Stair Riser Height 7-1/2 Inch
Stair Tread Width 10 Inch
On-Center Spacing 16 Inch
Weight per Volume 1.5 Tons/Cu Yd
If you replace your batteries or perform a
Full Reset * (press O, hold down x, and
press o), your calculator will return to
the following settings (in addition to those
listed above):
PREFERENCE SETTINGS DEFAULT VALUE
Fractional Resolution 1/16
Area Display Standard
Volume Display Standard
Meter Linear Display 0.000
Decimal Degree Display 0.00°
Fractional Mode Standard
*Depressing the Reset button located above the
p key will also perform a Full Reset.
Auto-Shut Off
Your calculator will shut itself off after
about 8-12 minutes of non-use.