Calculated Industries Construction Master 5 - Entering and Converting Dimensions; Linear and Square;Cubic Entry

52 pages

To Next Page

To Previous Page

POCKET REFERENCE GUIDE — 13

ENTERING DIMENSIONS

Linear Dimensions

When entering Feet-Inch values, enter

dimensions from largest to smallest —

Feet before Inches, Inches before

Fractions. Enter Fractions by entering the

numerator (top number), pressing /

(Fraction Bar key) and then the denomina-

tor (bottom number).

Note: If a denominator is not entered, the frac-

tional setting value is used.

Examples of how linear dimensions are

entered (press

after each entry):

DIMENSION KEYSTROKES

5 Yards 5 y

5 Feet 1-1/2 Inch 5 f 1 i 1 / 2

17.5 Meters 1 7 • 5 m

Square and Cubic Dimensions

Examples of how Square and Cubic

dimensions are entered (press

after

each entry):

DIMENSION KEYSTROKES

5 Cubic Yards 5 y y y

130 Square Feet 1 3 0 f f

33 Square Meters 3 3 m m

Other manuals for Calculated Industries Construction Master 5