Calculated Industries Machinist Calc 4086 - Page 65

64 — Ma c h i n i s t ca l c ™/ Ma c h i n i s t ca l c ™ Pr o
3) Default Unit
Format
– US: unitless values stored within Machinist
functions are automatically assigned the
corresponding default U.S. units of the
selected function.
– METRIC: unitless values stored within
the Machinist functions are automatically
assigned the corresponding default Metric
units of the selected function.
4) Area Answer
Format
– Standard: if units entered are the same
– e.g., Feet x Feet – area answers will
remain in this format (Square Feet), but if
units entered are different – e.g., Inches x
Feet – area answers will be displayed in
Square Feet.
– Square Feet: area answers always
displayed in Square Feet, regardless of
unit entry – e.g., Inches x Inches = Square
Feet.
– Square Inches: area answers always
displayed in Square Inches, regardless
of unit entry – e.g., Feet x Feet = Square
Inches.
– Square Meters: area answers always
displayed in Square Meters, regardless
of unit entry – e.g., Feet x Feet = Square
Meters.
(cont'd)