20
Install lter into the lter canisterStep 6.
Note: Make sure you have removed and soaked the spa lter cartridge in a bucket of water for at least
30 minutes. This will remove air pockets inside of the lter.
When re installing the lter cartridge, do not over tighten the lter, the threaded bit inside of the lter
housing is made of a corrosion resistant ABS plastic. Excessive torque will break the internal threads
within the lter housing.
Test and Adjust Water ChemistryStep 7.
Test and adjust the water chemistry.
After a period of 5-15 minutes the priming mode will nish. The heater will then activate, put the spa
cover on and let the spa heat to the desired set temperature.
During the initial power up the spa, it will consume a large amount of energy to raise the water in the
tub to your desired hot tub temperature. Cal Spas are designed for high eciency, once the temperature
within the spa is reached, the spa will use lower amounts of energy to maintain the temperature.
Note: Cal Spas are designed to retain heat, if it is desired to lower the water temperature the spa does not
contain a cooling feature. To lower internal temperature of the spa, lower the set temperature on the con-
trol panel and open the tub during the evening or night to help release the heat captured within. You may
also drain 1/4 of the water within and rell with new water to lower temperatures rapidly.
Let the Spa Heat UpStep 8.
To Next Page
Loading...
