CAME BPT MTMV/08 User Manual

M2 M3
PROG
>3’’
PROG
1
1
A
B
C
1 P.E.
2 P.E. 2 P.E.
2 P.E.
1 P.E.
1 P.E.
2 P.E.
1 P.E.
E
D
Page 3 - Manual FB00884-EN - vers. 1 - 09/2017- © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice.
 For the basic unit (no call but-
tons), you do not need to press the
buttons that are shown as flash-
ing in figure
B 1.
Repeat for all entry panels to be
programmed. Once programming
is complete, the configuration is
implemented E and you are au-
tomatically taken to “programming
calls”.
Press the first call button on each unit C D (see “But-
ton numbering” section) until the blue LED
and the
button LEDs stop flashing.
 The LED lights on the unit remain on to show that
the buttons have been programmed correctly.
Programming buttons
PROGRAMMING ENTRY PANELS WITH VA/08
Entering programming mode
Press the PROG button on the power supply A until the
PROG LED lights up.
The LEDs
and and the button LEDs flash to show
the buttons are being programmed B.

CAME BPT MTMV/08 Specifications

General

Brand	CAME
Model	BPT MTMV/08
Category	Control Unit
Language	English