L N L1T L2T M N + E -
p. 16 - Manual FA00571-EN v. 1 - 08/2017- © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice.
ELECTRICAL CONNECTIONS
Connect all wires and cables in compliance with the law while using suitable cable glands, as shown in the drawing.
⚠
Use a cable gland only for the 230 V AC power supply cable.
⚠
The electrical cables must not touch any heated parts such as the motor, transformer, and so on.
24 V DC gearmotor with encoder
Brown
Blue
FACTORY WIRING
The gearmotor is already connected.
To install the barrier on the right, follow the instructions in the PREPARING THE BARRIER.
Ferrite
White
Brown
Green
To Next Page
Loading...
