p. 25 - Manual FA00571-EN v. 1 - 08/2017- © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice.
F63 COM speed
For setting the communication speed used in the CRP (Came Remote Protocol) connection system.
0 = 1200 Baud / 1 = 2400 Baud / 2 = 4800 Baud / 3 = 9600 Baud / 4 = 14400 Baud / 5 = 19200
Baud / 6 = 38400 Baud (default) / 7 = 57600 Baud / 8 = 115200 Baud
U1 Entering users
Entering up to 250 users and associating to each one a function of choice among those included.
Use a transmitter or other control device to enter the data (see paragraph called ENTERING A USER
WITH AN ASSOCIATED COMMAND).
1 = Step-step command (open-close) / 3 = Open only command / 4 = Partial opening/pedestrian
command (only for paired or alternate mode systems)
U2 Deleting users Deleting single users (see paragraph called DELETING SINGLE USERS)
U3 Deleting users
Deleting all users.
0 = Deactivated (default) / 1 = Delete
A1 Boom type
To establish the boom type.
Warning! The choice of boom type limits certain speed, slow-down and calibration limits. This is to
ensure proper operation of the barrier.
0 = do not use /2 = do not use /4 = 4 6 = 6 8 = do not use
A2 Motor test Test to check the right direction of travel of the boom (see paragraph called MOTOR TEST).
A3 Travel calibration
Automatic calibration of the boom travel (see paragraph called TRAVEL CALIBRATION).
This function appears only is the Encoder function is activated.
A4
Resetting
parameters
Attention! The default settings will be restored.
0= Deactivated (default) / 1= Activated
A5 Maneuver count
For viewing the number of maneuvers done by the boom (1 = 1,000 maneuvers; 100 = 100,000
maneuvers; 999 = 999,000 maneuvers)
A7
Duration of boom
slow-down during
closing
This sets the duration of the boom's slow down between the maneuvering and slow-down speeds
when closing (see fi gure A).
This function appears only if the Encoder function is activated.
1 = Minimum / 2 = Medium ( default ) / 3= Maximum
H1 Version View the fi rmware version.
Maximum duration
of deceleration
Average duration
of deceleration
(default)
Minimum
duration of
deceleration
To Next Page
Loading...
