CAME KR300 - Gearmotor Mounting and Wiring; Fastening the Gearmotor; Connecting to the Control Panel

W V U W V U
ZA3N - ZA3P
󱤨
󱤩
p. 8 - Manual FA01158 -EN - 02/2023 - © CAME S.p.A. - Translated original instructions
Open the leaf, fit the pinion into the gate brace and fasten it using the supplied washer and nut.
Connecting to the control panel
⚠
Warning! Before working on the control panel, cut off the main current supply and, if present, remove any batteries.
Fastening the gearmotor
Lubricate the bushing 󱤨 and fit into one of the post brace holes (the holes on the brace are for varying the gate's opening angle.
Fasten the joint 󱤩to the post brace using the bolt and nut.
230 V AC gearmotor fi tted on the left (inside
view), with delayed opening.
230 V AC gearmotor fi tted on the right (inside
view), with delayed closing.