CAME V900E - Opening Phase Programming

15
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
#,3%.3
:,
/03%.3
-/4/2&53%
!&


/.
!## &53%!&
,).%&53%
!&
/0%.
/0#,
!&
6 6 6
-.

%
%.#2!$)/
!#4
3,/73%.3
#,3%.3
:,
/03%.3
-/4/2&53%
!&


/.
!## &53%!&
,
).%&53%
!&
/0%.
/0#,
!&
6 6 6
-.

%
%.#2!$)/
!#4
3,/73%.3
#,3%.3
:,
/03%.3
-/4/2&53%
!&


/.
!## &53%!&
%
&53%

!&
/0%.
/0#,
!&
6 6 6
-.

%
%.#2!$)/
!#4
3,/73%.3
#,3%.3
:,
/03%.3
-/4/2&53%
!&


/.
!## &53%!&
.
%&53%

!&
/0%.
/0#,
!&
6 6 6
-.

%
%.#2!$)/
!#4
3,/73%.3
#,3%.3
:,
/03%.3
-/4/2&53%
!&


/.
!## &53%!&
.
%&53%
!&
/0%.
/0#,
!&
6 6 6
-.

%
%.#2!$)/
!#4
3,/73%.3
...then briefly press the ENC/RADIO button (if the signal led stays on for some seconds and then starts flashing again, the
programming operation is satisfactorily complete).
- Push and keep pressed the OPEN button until the door is fully open...
Programming the end-stop in the opening phase
...then briefly press the ENC/RADIO button (if the signal led stay on the programming operations is satisfactorily complete).
Finally, set dip switch n°1 back to OFF.
TEST
Use the AP/CH button to command both an opening and a closing to verify whether the programmino was successful.