Page 6 - Manual FA02007-IT - 11/2023 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructions
Cable types and minimum thicknesses
Connection
cable length
< 20 m 20 < 30 m
Input voltage for 230 V AC control board
(1P+N+PE)
3G x 1.5 mm
2
3G x 2.5 mm
2
Signalling devices 2 x 0.5 mm
2
Command and control devices 2 x 0.5 mm
2
Safety devices (photocells)
(TX = 2 x 0.5 mm
2
)
(RX = 4 x 0.5 mm
2
)
When operating at 230 V and outdoors, use H05RN-F-type cables that are 60245 IEC 57 (IEC) compliant;
whereas indoors, use H05VV-F-type cables that are 60227 IEC 53 (IEC) compliant. For power supplies up to
48 V, you can use FROR 20-22 II-type cables that comply with EN 50267-2-1 (CEI).
To connect the antenna, use the RG58 (we suggest up to 5 m).
If cable lengths differ from those specified in the table, establish the cable sections depending on the actual
power draw of the connected devices and according to the provisions of regulation CEI EN 60204-1.
For multiple, sequential loads along the same line, the dimensions on the table need to be recalculated
according to the actual power draw and distances. For connecting products that are not contemplated in this
manual, see the literature accompanying said products
GENERAL INSTRUCTIONS FOR INSTALLING
⚠
Only skilled, qualified staff must install this product in full compliance with the law in force.
⚠
Caution! Before working on the control panel, cut off the mains power supply and remove any batteries.
The control panel is set up for:
- connecting the RGP1 module for reducing energy consumption;
- connecting the RLB card for emergency operation and battery-recharging;
All connections and links are rapid-fuse protected.
Fuses
HD Analog 2 A-F = 230 V
Accessories / board 2 A-F
To Next Page
Loading...
