p. 7 - Manual FA01082-EN - 02/2018 - © CAME S.p.A. - Translation of the original instructions
Fastening the control panel
Fasten the control panel in a
protected area; use rounded cross head
screws with maximum 6 mm diameter.
maximum 6 mm diameter.
Perforate the punched holes.
Hole diametre: ø 20.
Be careful not to damage the control
board inside the casing.
Enter the cable gland with the
corrugated tubes for threading the
electrical cables.
Assembling the pressure hinge
Fit the hinges into the box (either on
the right or left) and fasten them using
the supplied screws and washers. They
slide to rotate.
Tools and materials
Make sure you have all the tools and materials you will need for installing in total safety and in compliance with applicable
regulations. The figure shows some of the equipment installers will need.
To Next Page
Loading...
