Section 01 TECHNICAL MANUAL
Subsection 01 (DYNAMIC POWER STEERING (DPS))
– Steering column shim adjustment at half bush-
ings as described in the
DPS UNIT INSTALLA-
TION
procedure detailed in this section.
–
TORQUE OFFSET RESET
procedure detailed in
this section.
–ReplaceDPSunit.
DPS Unit Removal
1. Remove the following items:
–Seat
–Centerpanel
– LH and RH side panels
– LH and RH inner fender panels.
2. Lift up on the dash board (gauge support) and
disconnect the following:
–Gauge
– Ignition switch
– 12 Vdc power outlet.
3. Remove dash board from vehicle.
4. Remove the screw securing the shift lever
guide plate to the engine air filter housing.
vmr2006-014-055_d
TYPICAL
1. Shift lever guide plate
2. Guide plate screws (forward screw not visible)
NOTE: It is not necessary to disconnect the shift
lever.
5. Loosen the gear clamp securing the air filter
housing duct to the throttle body.
vmr2010-003-012_a
1. Gear clamp to loosen
6. Remove the screws securing the engine air fil-
ter housing.
7. Move the shift lever and guide plate slightly to
the right.
8. Lift up on the air filter housing to release it from
the throttle body and move the filter housing
towards the RH side of the vehicle.
NOTE: Moving the air filter housing to the right
provides access required for CVT air inlet duct re-
moval.
9. Remove the CVT air inlet duct assembly.
vmr2010-003-011_a
1. CVT air inlet duct
10. Remove the ECM from it's support bracket.
11. Disconnect the 3 electrical connectors from
the DPS unit.
14 vmr2010-003
To Next Page
Loading...
Need help?
General
