M52 Microprocessor User's Guide
M52UMCT Oct-03 33
Temp. I-time Integral action time constant used in the PID control loop
Humid. I-time Integral action time constant used in the PID control loop
Humid. Control Choose to enable or disable humidity control.
Setback Humid. Series 9 only, allows an alternate humidity setpoint to be selected and
controlled by a digital input signal by others
Notes:
1
Alarms activate only if they are enabled in the Alarm Configuration section.
2
These parameters
are to be used only when performing a calibration check of the unit sensors. Do not adjust, as
this will cause the unit to malfunction.
To Next Page
Loading...