M52 Microprocessor User's Guide
M52UMCT Oct-03 42
Only one operator can use the key pad at a time. Once you logon to the network that unit
becomes the master. All other units will be locked and the keypads will display Master Lock
if you attempt to use them.
When an alarm condition is detected the alarm is broadcast to all units in the network. The
alarm can be acknowledged at any unit in the network.
When reviewing alarm in the Alarm tab or in the Historical Event log you must pay attention
to the PC board address to properly identify which unit in the network is alarming. This is
the two digit address that appears to the left of the event occurrence time in the Historical
Event tab and the Alarm tab. Events such as Unit on/off and Power Failure/Restore are
shown for the individual unit being poled.
You can program the network to display the temperature and humidity of the site (average of
all readings) or the individual temperature and humidity of the unit under the Settings tab.
Refer to the Setting section
To Next Page
Loading...