During the SHOW_Survey function, the bottom line indicates the available
commands such as:
INC→ Next Entry display the next survey location entry
SET → Last Entry display the last survey location entry
MODE → Exit Survey. exits survey mode and returns display to Rate
mode.
During the TAKE - Survey function, the user has two options.
1. Keep or Zero the old (existing) survey entries.
SET→ KEEP old
INC → ZERO old
2. User/Keypad or Bar Code Reader location entry.
SET → Use BarCode
INC → NO BarCode.
2.2.3.13 SCALER MODE
The Scaler mode provides a useful summing function for count rate probes over a
user selectable period. This allows accurate objective recording to be made of
samples without any mental averaging of displayed count rates by the operator. For
example, if smear samples from a suspected contaminated area are to evaluated, a
one minute scaler could be made of each smear sample. Although the Scaler mode is
available for dose rate probes and the ADM300 alone, the dose is indication
provides the same function.
2.2.3.14 TURNING THE UNIT OFF
Press and hold POWER ON/OFF switch for two seconds to turn the unit OFF.
Note: When the survey meter is turned OFF with batteries still installed, the
previously set alarm values are unaffected, and are restored unchanged when the
power is turned ON.
Note: ADM300 Kits A AND C contain external probes. Follow procedures in
section 2.2.5, External Probe Operation, for applicable probes.
2.2.3.15 STORAGE
Remove accessories such as handle, carrying strap, and probe cable from ADM300.
Remove batteries from ADM300 if unit will be inactive for more than a month.
Place all units and accessories in the carrying case.
27
To Next Page
Loading...
