CandCNC
Page 12
DISCLAIMER AND LEGAL NOTICE
The following section covers the installation of a Voltage Divider card inside the plasma unit.
There are dangerous and possibly lethal voltages present in a plasma power supply/unit.
ALWAYS UNPLUG THE UNIT FROM THE AC POWER BEFORE REMOVING ANY COVERS.
ALWAYS REPLACE ALL COVERS AND SAFETY BARRIERS BEFORE TURNING THE
POWER BACK ON.
You do any install of a card inside of your Plasma Power Unit AT YOUR OWN RISK. If you
do not wish to do the procedure either find a person qualified to do so OR contact us for
options.
CandCNC/Fourhills Designs (hereafter referred to as “CandCNC”) nor any of its
resellers or agents will be responsible for any damage to any plasma unit or the loss of
any income resulting from using any of our electronics or using our instructions written or
verbal to connect to any electronics. While we take care to provide accurate and concise
information, we will not be responsible for any damages to equipment, personnel, or
surrounding equipment, structures or land resulting from the direct or indirect use of our
products.
The entire liability of CandCNC or any of its agents or employees is to replace or
repair products provided by CandCNC. Under no circumstances will we be liable for any
damages or loss exceeding the value of the actual products provided by us regardless if the
products are used as described and in the proper manner. All CandCNC products carry a
warranty that covers repair or replacement ONLY. Any labor, travel expense or costs to
replace a component or product outside the CandCNC factory is NOT COVERED by
warranty.
If you do not accept the terms of this notice DO NOT OPEN OR INSTALL THE
RAV-01 CARD. Return the card for a full refund and seek an alternative way to sense
the voltage.
CAUTION: Some plasma units use a very high voltage spark (Capacitor Discharge
or CD) arc starting system. While the RAV-01 card is protected from high voltage inputs
CD type systems can cause arcing in the connecting wires or to nearby components.
If you have a CD start unit and do not have experience working with high voltage systems
SEEK PROFESSIONAL HELP to do any install.
USING RAW ARC VOLTAGE CARD
E
To Next Page
Loading...