C&T PC400 Series - Set Torque Force to 3.5 Kgf-CM to Execute All the Screwing and Unscrewing; Installing SODIMM

PC400 / PC410 l User’s Manual
3.1 Set torque force to 3.5 kgf-cm to execute all the screwing and
unscrewing
3.2 Installing SODIMM
1. Remove SODIMM cover in the below circled area for installing memory module.
2. Insert memory module from 45 degree direction.
3. Press the memory module vertically downward until you hear the “click” sound. Make sure
the memory module is firmly in place.
34
Chapter 3: System Setup
In order to prevent electric shock or system damage, before removing the
chassis cover, must turn off power and disconnect the unit from power source.
WARNING