Candy CH64EXCP - General Warnings; Protect on of the Env Ronment; Installat on

When nstallng a hood above
the hob, please consult the
nstallaton requrements
specfed for the hood but, n
any case, the dstance between
the hob and the hood must not
be lower than 700 mm.
Leave a dstance of at least 55
mm between the hob and the
back wall and of at least 150
mm between the hob and the
vertcal furnture or walls n the
lateral sde. If a furnture s
nstalled above the hob, the
mnmum dstance requred s
700 mm.
PRODUCT CODE T
Identification Plate (located under the hob's bottom casing)
1. GENERAL WARNINGS
By placng the mark on ths applance we are assurng
complance to all European Safety, Health and Envronment
requrements whch are applcable for ths product category.
2. PROTECTION OF THE ENVIRONMENT
• WEEE shall not be threatened as household waste.
Individuals can play an important role in ensuring that the WEEE
does not become an environmental issue; it is essential to follow
some basic rules:
This appliance is marked according to European
Directive 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE).
• In many Countries, when you buy a new appliance, the old one
may be returned to the retailer who has to collect it free of charge on
a one-to-one basis, as long as the appliance is of equivalent
typology and has the same functions as the supplied one.
• WEEE shall be handled over to the relevant collection points
managed by the municipality or by registered companies. In many
Countries, for large WEEE, home collection could be present.
WEEE contains both polluting substances (which
can cause negative consequences for the
environment) and basic components which can be
reused.It is important to have WEEE subjected to
specific treatments, in order to remove and dispose
properly all pollutants and recover and recycle all
materials.
3. INSTALLATION
Applance can be nstalled n a Bult-n furnture n “Standard” or “Flush”
mode.
Make sure that the furnture n whch the applance wll be ftted and all
other furnture n the nearby are made wth mater
In the event that ths advce t s gnored and nstallaton s carred out
by an unqualfed person, the Manufacturer declnes all responsblty
for any techncal falure of the applance whether or not t results n
damage of goods or propertes or n njury of people or anmals.
Installng a domestc applance t s a complcated operaton whch, f
not carred out correctly, can serously have mpact on safety of goods,
propertes or people. For ths reason, t should be carred out by a
professonally qualfed person n accordance wth techncal
regulatons.
After havng removed the packagng please be sure that the applance
t s not damaged, otherwse contact the Retaler or Manufacturer After
Sales Servce.
ls whch can wthstand hgh temperatures (mn 100 °C).
In addton, all decoratve lamnates should be fxed wth hgh-resstance
glue.
700 mm
55 mm
150 mm
490 mm
+ 2
- 0
560 mm
+ 2
- 0
Mn. 70 mm
Standard nstallaton
permeter
Note: Inner permeter dmensons are same wth standard nstallaton
703 mm (70 cm hob)
+ 2
- 0
523 mm
+ 2
- 0
593 mm (60 cm hob)
+ 2
- 0
Slot depth: 5 mm
Flush nstallaton
permeter
Worktop thckness should be between 25 and 45 mm.
If the bottom part of the hob is adjacent to an area normally accessible
for handling or cleaning operations, a separator it must be put 20 mm
below the bottom part of the hob.
mn 20 mm
When nstallng an oven under the hob, separator must not be put and
the mnmum dstance between the bottom part of the hob and the
oven must not be lower than 10 mm. Do not nstall not cooled oven
under ths hob and nstall the oven followng ts own nstallaton
requrements.
10 mm
min
05 GB