EasyManua.ls Logo

Candy CY-09QBIN - Maintenance

Candy CY-09QBIN
288 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
English
Maintenance
Setting of proper room
temperature.
Close doors and windows
during operation.
Use the timer e󰀨ectively.
Air Filter cleaning
Use the louvers e󰀨ectively
If the unit is not to be used
for a long time, turn o󰀨 the
power supply main switch.
Do not block the air inlet or
outlet.
Remote Controller
Do not use the following for cleaning
Do not use water, wipe the controller with
a dry cloth. Do not use glass cleaner or
chemical cloth.
Gasoline, benzine, thinner or cleanser
may damage the coating of the unit.
Hot water over 40 °C (104 °F) may
cause discoloring or deformation.
Indoor Body
Proper
temperature
During cooling
operation prevent
the penetration of
direct sunlight with
curtain or blind.
For Smart Use of The Air Conditioner
1.Open the inlet grille by pulling it upward.
2.Remove the lter.
Push up the lter's center tab slightly until it is
released from the stopper, and remove the lter downward.
3.Clean the lter.
Use a vacuum cleaner to remove dust, or wash the lter with water. After washing,
dry the lter completely in the shade.
4.Attach the lter.
Once every
two weeks
OFF
Attach the lter correctly so that the "FRONT" indication
is facing to the front. Make sure that the lter is
completely xed behind the stopper. If the right and
left lters are not attached correctly, that may cause
defects.
5.Close the inlet grille.
wipe the air
conditioner by
using a soft and dry
cloth. For serious
stains, use a neutral detergent diluted
with water. Wring the water out of the
cloth before wiping, then wipe o󰀨 the
detergent completely.
Detach old Air Purifying
Filter
1.Open the lnlet Grille
Prop up the inlet grille by using a
small device named grille-support
which located in the right side of
the indoor unit.
2.Detach the standard air lter
Slide the knob slightly upward to
release the lter, then withdraw it.
3. Attach Air Purifying Filter
Put air purifying lter appliances into the
right and left lter frames.
4. Attach the standard air lter
(Necessary installation)
ATTENTION:
The white side of the photocatalyst
air purifying lter face outside, and
the black side face the unit the green side of the bacteria-killing
medium air purifying lter face outside, and the white side face
the unit.
5.Close the Inlet Grille
Close the Grille surely.
NOTE:
●The photocatalyst air purifying lter will be solarized in xed
time. In normal family, it will be solarized every 6 months.
●The bacteria-killing medium air purifying lter will be used for
a long time, no need for replacement. But in the period of using
them, you should remove the dust frequently by using vacuum
cleaner or apping them lightly, otherwise, its performance will
be a󰀨ected.
●Please keep the bacteria-killing medium air purifying lter in the
cool and dry conditions avoid long time directly sunshine when
you stop using it, or its ability of sterilization will be reduced.
Replacement of Air Purifying Filter

Table of Contents

Related product manuals