5-7
Specifying Camera Settings from Your Computer
Personal Function Settings
P.Fn-01
P.Fn-02
P.Fn-03
P.Fn-04
P.Fn-05
P.Fn-06
P.Fn-07
P.Fn-08
P.Fn-09
P.Fn-10
P.Fn-13
P.Fn-14
P.Fn-15
P.Fn-16
P.Fn-17
P.Fn-18
P.Fn-19
P.Fn-20
P.Fn-21
P.Fn-23
P.Fn-24
P.Fn-25
P.Fn-27
P.Fn-28
You can specify the Personal Function settings listed below in the different tab sheets.
[Exposure Functions 1]
Disables the shooting modes. (➞5-9)
Disables the metering modes. (➞5-9)
[Exposure Functions 2]
Specifies the metering mode for manual exposure. (➞5-10)
Sets the maximum and minimum shutter speeds to be used. (➞5-10)
Sets the maximum and minimum apertures to be used. (➞5-11)
[Exposure Functions 3]
Registers and switches the shooting mode and metering mode. (➞5-11)
Repeats bracketing during continuous shooting. (➞5-13)
Sets the number of shots to be bracketed. (➞5-13)
Changes the bracketing sequence for C.Fn-9-2/3 to increased exposure, stanadrd exposure, and decreased exposure. ( ➞5-13)
Retains the shift amount for program shift. (➞5-14)
[AF Functions]
Executes AI Servo AF continuous shooting giving priority to the drive speed. (➞
5-15
)
Disables focus detection (search driving) by the lens drive. (➞5-15)
Disables the AF-assist beam from being emitted. (➞5-15)
Enables automatic shooting when focus is achieved at the fixed point of focus while the shutter button is pressed fully. (➞5-16)
Disables automatic AF point selection (➞5-16)
Enables automatic AF point selection when C.Fn-11-2 has been set. (➞5-17)
[Drive Functions]
Sets the continuous shooting speed. (➞5-17)
Limits the number of shots during continuous shooting. (➞5-17)
Enables silent operation when the shutter button is OFF after picture-taking. (➞
5-18
)
[Other Functions 1]
Changes the timer’s time length. (➞5-18)
Illuminates the LCD panel during bulb exposures. (➞5-19)
[Other Functions 2]
Sets the default settings when the CLEAR (QUALITY+WB) button is ON. (➞
5-19
)
[Other Functions 3]
Enables the electronic dial’s function to be used in the reverse direction. (➞5-20)
Prevents exposure compensation with the Quick Control Dial. (➞5-20)
[Combination]
Allows you to check the settings (➞5-21)
Allows you to save the settings (➞5-22)
Allows you to load the saved settings (➞5-23)
* Omission of P.Fn-11, 12, 22 and 26
The numbers and descriptions for P.Fn-0 to P.Fn-28 contain some omissions due to the fact
that some functions on the EOS-1V are omitted on the EOS-1D, but the same Personal
Function numbers are used on both models.
To Next Page
Loading...
