75
d Program AE
¡ If “30"” and the maximum aperture blink, it indicates
underexposure. Increase the ISO speed or use flash.
¡ If “8000” and the minimum aperture blink, it indicates
overexposure. Decrease the ISO speed or use an ND
filter (optional) to reduce the amount of light entering the
lens.
Differences Between <d> and <1> (Full Auto)
¡ In both modes, you can freely change the automatically-set shutter
speed and aperture combination (program).
¡
In the <
d
> mode, you can set or use the functions below, but not in the <
1
> mode.
Shifting the Program
¡ In Program AE mode, you can freely change the shutter speed and
aperture value combination (program) set by the camera while
maintaining the same exposure value. This is called program shift.
¡ To do this, press the shutter button down halfway, then turn the <6>
dial until the desired shutter speed or aperture value is displayed.
¡ Program shift is canceled automatically after the image is captured.
¡ If you are using a flash, you cannot shift the program.
Shooting Settings
¡ AF mode selection
¡ AF point selection
¡ Drive mode selection
¡ Metering mode selection
¡ Program Shift
¡ Exposure compensation
¡ AEB
¡ AE lock with <A> button
¡ Depth-of-field preview
¡ Clear all camera settings
¡ Custom Function (C.Fn)
¡ Clear all Custom Functions
¡ Sensor cleaning
Flash Settings (Built-in flash)
¡ Flash On/Off
¡ FE lock
¡
Flash exposure compensation
Flash Settings (EX-series Speedlite)
¡ Manual/Stroboscopic Flash
¡ High-speed sync (FP flash)
¡ FE lock
¡ Flash ratio control
¡ Flash exposure compensation
¡ FEB
¡ 2nd-curtain sync
¡ Modeling Flash
Image-Recording Settings
¡ RAW and RAW+JPEG selection
¡ ISO speed
¡ White balance selection
¡ Custom white balance selection
¡ White balance correction
¡ WB bracketing
¡ Color temperature setting
¡ Color space selection
¡ Processing parameter setting
To Next Page
Loading...
