264
Connecting the camera to a TV set is recommended to play back the
shot movies (p.357-359).
When the shooting mode is set to any mode other than <
a
>,
autoexposure control will take effect to suit the scene’s current brightness.
1
Set the power switch to <k>.
The reflex mirror will make a sound,
then the image will appear on the
LCD monitor.
2
Set the Mode Dial to a mode other
than <8>, <v>, or <a>.
3
Focus on the subject.
Before shooting a movie, focus with
AF or manual focus (p.247-256, 259).
By default, [Movie Servo AF:
Enable] is set so that the camera
always keeps focusing. To stop Movie
Servo AF, see page 303.
4
Shoot the movie.
Press the <A> button to start
shooting a movie. To stop movie
shooting, press the <A > button
again.
While the movie is being shot, the
“o” mark will be displayed on the
upper right of the screen.
Sound will be recorded by the built-in
microphones.
k Shooting Movies
Autoexposure Shooting
Recording movie
Built-in microphones
To Next Page
