Control Panel
System Setup
Setting Item Description, Instructions
Buzzer Set the buzzer . Choose On for the buzzer to sound once for
warnings and three times for errors.
W arning
Detect Mismatch Choose W arning for notication (display of a warning
message) during printing if the paper type specied in
the printer menu does not match the paper type in the
printer driver . Choose None to continue to print without
notication. Choose Pause to have printing paused under
these circumstances. In this case, you can continue printing
by pressing the Online button.
Keep Media Size Select On to use the paper size setting as the basis for
printing instead of other settings. The margin setting of the
printer menu will be used instead of the margin setting of the
printer driver if the latter is smaller , which may prevent text or
images in the trailing margin from being printed.
Choose Off to use the printer driver settings instead. Even if
the margin setting of the printer driver is smaller than that of
the printer driver , text or images will not be cut of f. However ,
this requires longer paper because the actual margin will be
equal to the margin setting of the printer driver plus the margin
setting of the printer menu.
Sht Selection If sheet size detection is activated, choose whether ISO A3+
or 13"x19"(Super B) is applied when an intermediate size is
detected.
Roll Selection 1 If roll size detection is activated, choose whether ISO A3
(297mm) or 300mm Roll is applied when a roll of an
intermediate width is detected.
Paper Size Basis
Roll Selection 2 If roll size detection is activated, choose whether 10in.
(254mm) or JIS B4 (257mm) is applied when a roll of an
intermediate width is detected.
T rimEdge Reload When Automatic is selected, the leading edge will be cut as
needed, taking into account how long the paper has been
loaded without being printed. (However , it is not cut if Cutting
Mode is set to Manual .)
Choose On to cut the leading edge.
56 Printer Parts
To Next Page
Loading...
Need help?
General